German agent in concrete PantarNit goes to the Belarusian market
Post Alex Tymoshenko (ICHSP "plant Shyurynh-concrete"), issued on scientific and technical seminar "Chemical additives in concrete. Energy efficient technologies. ICHSP "Shyurynh-concrete factory was established in Minsk in 2007 and produces high quality concrete. It is stationary and mobile mixer settings in Germany, Austria, Luxembourg, Norway, Bohemia, Poland and Belarus, precast concrete plant in Dresden. (In Germany itself the attention of the company Schuering 1990) Today, all the concrete used in construction in developed countries, including various chemical additives.
Traditional and new chemical additives that are introduced as a stage production of cement, and on foot concrete mix, stimulate progress in the production and laying of concrete. This is the primary problem of compatibility with modern additions tsementami. This is done to directional regulation rovaniya properties of concrete mixtures at the stages of preparation, transportation, laying and curing concrete. In the Belarusian market ICHSP "plant Shyurynh-concrete offers new additive PantarNit Rc360. Currently, using this additive is prepared 70% of the concrete, the made in Germany. This high-quality modern concrete usually has a high frost resistance, increased durability, ultra durable and waterproof unconditionally. With the use of additives reduced facilities in Frankfurt, Munich, Norway. This addition of new generation superplasticizer based on modified acrylic polymers for concrete that samouplotnyayuschehosya, low vodotsementnym ratio is very high mechanical strength and long preservation of subsidence of the cone, which differs from conventional PantarNit superplasticizer based on naphthalene-sulfonate or Melamine-sulfate. According to test reports BELNIYIS this addition refers to the 1st group superpl astifikatorov. Acquired technical certificate means that you can sell supplements PantarNit consumers. Especially PantarNit fitting for such a situation ready-mixed concrete, when to strongly reduce the amount of water under very high mechanical strength at an early age in different classes and consistency with long periods of concrete retaining lehkoukladuvanosti. These qualities allow the use of additives and to produce concrete that samouplotnyayuschyhsya because PantarNit provides high lehkoukladuvanist. This mobility increases with the concrete mixture P1 to P5 while maintaining constant vodotsementnoho relationship with a simultaneous increase of concrete strength and concrete mix vodopotreby decrease by 15-20%. The main area of application is the production of additives PantarNit concrete with high mechanical characteristics (strength rating in the range 25-400 H/mm2) at long time for the initial lehkoukladuvanosti in odostoykyh and durable structures according to the standard EN 206-1 and concrete that samouplotnyayuschyhsya. Make the conclusion of concrete mixture with addition possible to malooperatsiyniy or bezoperatsyonnoy technology. Extra PantarNit saves 10-20% of cement (depending on the quality of composite concrete mix), increase vacation and project strength by 30-40% and significantly improve the performance of waterproof, frost and save Peru. With all the above process becomes easier and more efficient, and modular products in the excerpt, this additive reduces the heat treatment cycle without changing prochnostnyh and the performance or completely abandon the heat treatment. Extra PantarNit can provide advantages when used in these cases. Firstly, when the goal pursued by reducing the water content in comparison with the concrete without additives in similar lehkoukladuvanosti (thus achieved an increase of mechanical strength). In at-second, when the goal pursued by increasing water resistance and durability. Thirdly, when pursued the objective of increased perekochuvanosti concrete mix while retaining its mobility and rate rasslayivayemosti, vodootdeleniya and rastvorootdeleniya mixture before and after pumping it through the pump. And making the molten plastic and concrete mixes, reducing the time necessary to design and manufacture of products, reduce cycle heat treatment products, lower temperature isothermal heating or even exclusion of heat treatment as such. Use of additives PantarNit to reduce construction time buildings and structures, forms and reversible increase production, which creates additional economic benefit, to receive concrete high environmental marks 600 and above, 1.5 times reduce the time of concreting by high lehkoukladuvanosti concrete mixture, reduce the time of conclusion, energy consumption and 30 % labor. Extra PantarNit not Sodi rzhit chlorides and other corrosion causing materials and fittings can be used in the manufacture of precast concrete. This yellowish transparent viscous liquid (45% solution), which is subject to further dilution with water.
Structure and consistency are determined by laboratory road. Stored in closed, frozen at temperatures below -15 ° C, shelf life - 12 months. The estimated cost of 1 kg of additive in the Belarusian market - Br2200 VAT. Sergei Zolotov